IMA-AS filters are used to remove arsenic from drinking water from wells and mains, obtaining water suitable for human consumption.

Arsenic being present in water can cause health problems when ingested in large concentrations, this makes it necessary that in places where this concentration exceeds 10 ug/l, filters are installed to reduce the arsenic in the water.

Characteristics of automatic industrial arsenic filters IMA Water

• Connections:
  • 4 inch Filters diameter 780mm.
  • 6 inches filters diameter 1088,1250,1600mm.
• Maximum working pressure 150 psi.
• Working temperature 0ºC to 35ºC.
• Limits of use:
  • Recommended PH: 6.5.
  • High amounts of sulfates, arsenates, phosphates and silicates. May create screen and reduce performance.
  • Complete water analysis recommended. Additional treatment may be necessary.
• Body constructed of fiberglass reinforced polyester.
• Automatic diaphragm valves, mounted on the front of the column. Water cut-off during washing.
• Controller programmed for washing cycles.
• Inner distributors suitable for the design flow rate.
• Complete with ferric hydroxide filtering load.

Equipment included in the IMA water automatic arsenic removal filters.

• Valve front with inlet/outlet control gauges.
• Filter bed to remove arsenic.
• Discharge port for replacement of 4-inch filter bed in 1088, 1250 and 1600 diameter filters.
• Upper and lower strainer kit.

Contact us without obligation by phone or email for any technical advice or purchase of our equipment.